Sony HVR-M10C, Руководство по обслуживанию

Страница: 264 / 329

26
Chapter 2 Playback and Recording
Chapter 2 Playback and Recording
Connecting the unit to a monitor without
an i.LINK jack
You can connect this unit to video monitor without an
i.LINK jack. Use this unit as follows.
Notes
• To playback the picture recorded in the HDV format
when you connect the monitor using a component
video cable, set [COMPONENT] on the [IN/OUT
REC] menu according to your monitor (p. 49). When
the picture recorded in the DVCAM/DV format is
play back, only a picture with a quality equivalent
with the DVCAM/DV format is output regardless of
the [COMPONENT] setting.
• The output level of the COMPONENT OUT jack is
as follows:
Y: 1 Vp-p (480i NTSC/576i PAL: 0.3 V sync
negative)
Pb/Cb, Pr/Cr: 700 mVp-p (100% color bar), output
impedance 75
Ω (ohms)
To connect the unit to the other equipment,
conversion may be required in some cases.
Monitor
Audio input
Component video input
Video input
S-video input
Audio cable (Phono jack) (not supplied)
Component video cable (not supplied)
Video cable (not supplied)
S-video cable (not supplied)
Rear view of the player
(this unit)
• There are some restrictions on using EE pictures
output from the COMPONENT OUT jack of the unit.
Refer to
4
COMPONENT OUT (OUTPUT) jack in
“Location and Function of Parts” on page 15.
• If you connect the input connectors of this unit to the
output connectors of a monitor, a humming noise
may be generated or the image may be distorted. If
these phenomena occur, use the INPUT SELECT
switch to select a signal that is not being input or
disconnect the cables.
• You cannot output the DVCAM/DV formatted
signals including copyright control signals through
the COMPONENT OUT jacks.
• This unit cannot output images recorded in the
DVCAM/DV format after up-converting the tape to
HDV.
: Signal flow
Playback