Sony HDV HVR-A1U, Руководство по обслуживанию

Страница: 211 / 437

6-52
HVR-A1J/A1U/A1N/A1E/A1P/A1C
22. Auto White Balance Check
RadarW RadarW RadarW RadarW RadarW
Subject Clear chart (All white frame)
Filter ND filter 1.0, 0.4 and 0.1
Measurement Point Displayed data of page: 1 (Note 3)
Measuring Instrument Adjusting remote commander
Specified Value 8000 to 8BC0
Note 1:
Perform “Auto White Balance Adjustment” and “Color
Reproduction Adjustment” before this adjustment.
Note 2: Check that the data of page: 0, address: 10 is “00”.
Note 3:
The right four digits of the page: 1 displayed data of the
adjusting remote commander.
1:XX:XX
Displayed data
Switch setting
1) POWER ............................................. CAMERA-TAPE mode
2) NIGHT SHOT .................................................................. OFF
3) DIGITAL ZOOM (Menu setting) .................................... OFF
4) STEADY SHOT (Menu setting) ..................................... OFF
5) FOCUS (Menu setting) .......................................... MANUAL
6) REC FORMAT (Menu setting) ............................. HDV1080i
Checking method:
Order Page Address Data Procedure
1
Check that the picture frame
is “All White Frame”. If not,
perform “11. Picture Frame
Setting (All White Frame)”
2 0 10 06
3
9
06 84 Press PAUSE (Write) button.
(69)
4 0 10 00
5 6 4D 40
6 6 CA
Set the bit value of bit0 is
“1”. (Note 4)
7 6 C9 10
Outdoor white balance check
8 6 01 4F Press PAUSE (Write) button.
9 0 03 33
10 1
Check that bit15 of the
display data (Note 3) is “1”.
(Note 5)
11 6 01 00 Press PAUSE (Write) button.
Indoor white balance check
12 6 01 0F Press PAUSE (Write) button.
13 1
Check that bit15 of the
display data (Note 3) is “1”.
(Note 5)
14 6 01 00 Press PAUSE (Write) button.
InOut data check
15
Place the ND filter 1.5 (1.0 +
0.4 + 0.1) on the lens.
16 6 C9 11
17 6 30 07
18 0 03 06
19 1
Check that the displayed data
(Note 3) satisfied the
specified value.
20 6 30 00
21 6 C9 00
22
Remove the ND filter 1.5
(1.0 + 0.4 + 0.1) on the lens.
Note 4:
For the bit values, refer to “6-4. SERVICE MODE”,
“4-4. 3. Bit value discrimination”.
Note 5: When bit15 of the display data is “1”, the display data is
“8000” to “FFFF”.
Processing after Completing Adjustment:
Order Page Address Data Procedure
1 0 03 00
2 6 4D 00
3 6 CA
Set the bit value of bit0 is
“0”.
4 0 10 06
5
9
06 14 Press PAUSE (Write) button.
(69)
6 0 10 00