Sony h.ear go 2, Руководство пользователя

Страница: 203 / 230

Help Guide
Wireless Speaker
h.ear go 2 (SRS-HG10)
The speaker cannot connect to a network using the UPDATE/WPS button
Cancel the group of the Wireless Surround function or Wireless Stereo function, etc. if you are using these functions.
Set up your network after searching the wireless router/access point using the PC connected to the speaker (access
point scan).
Update the firmware of the wireless router/access point to the latest version.
Press and hold the UPDATE/WPS button for about two seconds until beeps are heard.
Refer to the operating instructions of your wireless router to make sure you are operating the Wi-Fi Protected Setup
(WPS) button on the wireless router correctly.
Depending on the wireless router, press and hold the Wi-Fi Protected Setup (WPS) button for a few seconds. For
details, refer to the operating instructions of your wireless router.
Place the speaker closer to your wireless router.
If your wireless router has a Wi-Fi Protected Setup (WPS) button, you can connect to the Wi-Fi network by this
method. For details, refer to the operating instructions supplied with your wireless router.
If the settings are correct, try the following.
Turn off the wireless router/access point, wait a while and turn on the power again.
Turn off the speaker, wait a while and turn on the power again.
4-735-503-11(1) Copyright 2018 Sony Corporation
203