Sony film imager, Инструкция по эксплуатации

Страница: 9 / 39

Pre
par
at
ion
Connections
9
When placing the unit vertically
You can place the unit vertically if you attach the casters
provided. This is convenient for placing the unit under a
desk and to pull it out easily.
Notes
• Ask your nearest Sony dealer to attach the casters to
the unit.
• Use the casters to allow the unit to be pulled out from
under the desk and so on. Be sure not to use the casters
for moving the unit on an uneven surface.
• Place the stopper sheet (supplied) under a unit with
casters attached.
• When pulling the unit in and out while the unit is
equipped with the casters provided, be careful not to
damage the power cord, LAN cable, and so on.
• When placing the unit vertically, make sure the LCD
is near the floor, and leave a space of more than 8 cm
(3 1/4 inches) between the top of the unit and the
subject to prevent blocking the ventilation holes.
Connections
Connect the unit to the 100BASE-TX LAN.
Notes
• Connect the AC power cord last.
• Before connecting to the LAN, be sure to set up the
required IP address and sub-net mask.
For detailed information, consult the system
administrator.
• Before connecting the unit using a 100BASE-TX
cable, attach the ferrite cores provided to both ends of
the cable for noise prevention.
For detailed information on how to attach the ferrite
cores, see “How to attach the ferrite cores” (on
page 10)
Fix the front caster using the stopper sheet
(supplied).
Be sure to place the roller of the caster in the groove
of the stopper sheet.
Fix the unit using the front caster.
Stopper sheet
100BASE-TX cable
a)
to the LAN
Power cord (supplied)
to - AC IN
to the network connector
a) Be sure to use a network cable of less
than 30 m in length, and rated more than
category 5.