Sony DMW-IF02, Руководство по обслуживанию

Страница: 80 / 126

2-16
DMW-S01NL/S02NL/ST001
d) MTS-11 Board
(1) Remove the AV I/O block. (Refer to “Sec. 2-1-2”.)
(2) Remove the MPU-120 board.
(Refer to “Sec. 2-1-3, 2, step b)”.)
(3) Remove the YC-68 board.
(Refer to “Sec. 2-1-3, 2, step c)”.)
(4) Disconnect the three cables and one coaxial cable.
In case of DMW-S02NL (or DMW-S01NL with DMW-
IF02), disconnect the HDVD cable to add to above the cables.
(5) Remove the fourteen screws (BVTP3
x
8) of the rear
panel, remove the one nut and one washer of the “AUX2”.
. Service tool required
Jack nut driver ... Part No. : 7-700-742-02
(6) Remove the eight screws (PWH3
x
5) and remove the
MTS-11 board.
(7) Remove the RCA plate.
Nut
RCA plates
Coaxial cable
PWH3 x 5
BVTP3
x
8
TYPE2 N-S
BVTP3
x
8
TYPE2 N-S
Cables
MTS-11 board
HDVD cable
(DMW-S02NL only)
CN102
CN112
CN101
CN1
*
* When DMW-IF02 is installed in DMW-S01NL.
n
After replacing the MTS-11 board, be sure to perform the
operation check and adjustment, then perform the
reassembling of each parts.
c) YC-68 Board
(1) Remove the AV I/O block. (Refer to “Sec. 2-1-2”.)
(2) Remove the two screws (PWH3
x
5).
(3) Remove the three locking card spacers and remove the
YC-68 board.
PWH3
x
5
YC-68 board
MTS-11 board
Locking card
spacers
A A
Stopper
YC-68 board
Locking card
spacer
MTS-11 board
m
.
After replacing the YC-68 board, be sure to perform the
operation check and adjustment, then perform the
reassembling of each parts.
.
When reinstalling the YC-68 board, spread the stopper
of the locking card spacers in the arrow direction A,
because it fear that the stopper has come off from the
hole of MTS-11 board.
Adjustment after replacement of the YC-68 board
After replacing the YC-68 board, make sure to perform
the every electrical alignment items of this board by refer-
ring to Sec. 7, Electrical Alignment.
2-1. Digital media workstation/A/V block