Sony DMW-IF02, Руководство по обслуживанию

Страница: 74 / 126

2-10
DMW-S01NL/S02NL/ST001
PWH3
x
5
DSK-11 board
k) DSK-11 Board
(1) Remove the AV I/O block. (Refer to “Sec. 2-1-2”.)
(2) Remove the PCI duct.
(Refer to “Sec. 2-1-3, 1, b) Cabinet Fan step (2)”.)
(3) Remove the card stopper.
(Refer to “Sec 2-1-3, 1, b) Cabinet Fan step (3)”.)
(4) Remove the one screw (PWH3
x
5) and remove the
DSK-11 board.
m
.
When replacing the DSK-11 board, do not touch the
terminal portions of the board and also perform the
remedy for static electricity using ESD wrist band etc.,
to prevent not to damage it.
.
When reinstalling the DSK-11 board, be sure to put it
back to its place.
. After replacing the DSK-11 board, be sure to perform
the operation check, then perform the reassembling of
each parts.
Adjustment after replacement of the DSK-11 board
(1) After replacing the DSK-11 board, confirm that all the
S301 and S302 switches are OFF except S301-1 is ON.
(2) Confirm and test the following items using the disk
utility. (Refer to “Sec. 5-6-3”.)
If the disk utility does not set up normally, it considers
that poor contact may occurs. Therefore, insert the
DSK-11 board in the PCI slot again.
PWH3
x
5
AV processing board
j) AV Processing Board
(1) Remove the AV I/O block. (Refer to “Sec. 2-1-2”.)
(2) Remove the PCI duct.
(Refer to “Sec. 2-1-3, 1, b) Cabinet Fan step (2)”.)
(3) Remove the card stopper.
(Refer to “Sec. 2-1-3, 1, b) Cabinet Fan step (3)”.)
(4) Remove the one screw (PWH3
x
5) and remove the
AV processing board.
m
.
When replacing the AV processing board, do not touch
the terminal portions of the board and also perform the
remedy for static electricity using ESD wristband etc., to
prevent not to damage it.
. When reinstalling the AV processing board, be sure to
put it back to its place.
2-1. Digital media workstation/A/V block