Sony CCD-TRV67 - Video Camera Recorder 8mm, Руководство по обслуживанию

Страница: 43 / 228

2-13
2-14.HARNESS PROCESSING OF THE HINGE ASSEMBLY (TRV MODEL)
Hinge assembly
Straight in the direction
of attachemnt
Hinge cover (M)
Hinge cover (C)
Hinge cover (M)
(8P)
(Left side)
(Right side)
• Place a longer harness to the left side.
• Place the shortest harness (8P) in the right side to the bottom.
• Place the hooking portion of the harness clamp to
the right side.
• Place the harness clamp in the left of the tie
band himeron that ties the three wires.
• Insert the DP-78 harness in the internal groove of
the harness clamp.
Note:
• The harness must not be pinched.
•
The sheet of the FP-152 flexible board must not be peeled over.
Note:
• Be sure that the harnesses do not climb over the three ribs of the guide.
• Be sure that the harnesses are not pinched between the harness clamp and the shaft.
Note:
• Be sure that the harness is not pinched by the hinge cover.
• Be sure that the harness can move at the entrance/exit of the hinge assembly.
• While holding the harness clamp, turn the hinge upside down.
• While being careful not to twist the harness, insert the
longer harness (8P) into the shallow groove and insert the
other harnesses (6P, 12P) to the deeper groove.
• Hold the harness so that the harness must not come out from the groove.
• Be careful so that the hinge cover (M) must not contact with the switch
of the FP-152 flexible board.
• While holding the hinge cover (M) so as not to be dropped,
turn the hinge cover (C) upside down.
•
Route the harness inside the cutout of the hinge cover (M).
• Attach the hinge cover (C) straight. (Claw hooks at the four positions.)
• Make an attempt to move the harness gently at the entrance/exit of the hinge
assembly to make sure that the harness can move.
Longer harness (8P)
Two shorter harnesses (6P, 12P)
(8P)
(6P)
(6P)
(12P)
(12P)
Harness clamp
Harness clamp
Hinge bracket
Shaft
DP-78 harness
Himeron
Hooking
portion
Attach the harness clamp to the DP-78 harness.
Hook the two claws of the harness clamp on the hinge bracket.
Then attach it to the shaft of the hinge assembly.
Fix the harness using the harness guide of the hinge assembly.
Attach the hinge cover (M) to the hinge assembly.
Attach the hinge cover (C) to the hinge cover (M).
[ASSEMBLING THE HARNESS CLAMP]
[INSTALLING THE HARNESS CLAMP]
[HARNESS PROCESSING]
[ATTACHING THE HINGE COVER (M)]
[ATTACHING THE HINGE COVER (C)]