Sony BVP-570, Руководство по обслуживанию

Страница: 70 / 806

4-4 (E)
BVP-570
4-1. Preparation
How to change the setting values
To enter or cancel the setting value of items, which can be
changed by turning the MENU SEL switch, proceed as
follows.
To enter the setting value;
Press the MENU SEL switch to ENTER.
To cancel the setting value;
Before pressing the MENU SEL switch, press the CAN-
CEL button. The original setting is restored.
After pressing the MENU SEL switch, the setting can not
be canceled.
File Store
If the adjustments in this section are suspended or the unit
is powered off to extend a printed circuit board, be sure to
execute the FILE STORE before being powered off.
This section provides instructions to store the setting data
on the reference or trimming file in every adjustment item.
This intends to prevent the data from being cleared when
powered off.
The data is kept held unless powered off, and more than
one data can be stored at a time. Therefore, the file store
may not be necessarily executed for every adjustment item.
4-1-5. Description on Setup Menu
A part of adjustments given in this section uses the setup
menu. The setup menu consists of the following menus.
Besides there is a TOP menu indicating the entire configu-
ration of menu items.
.
Operation
.
Paint
. Maintenance
.
Reference File
.
Trimming File
.
System config
To display all of the menus, switch setting of the AT-126
board is required. And for details on the setup menu, refer
to Section 3.
In this manual, describes the setup menu operation as
follows.
Title of the selected page (top right corner display)
For example:
When Skin Detail in Paint menu is selected:
MENU : Paint
PAGE : Skin Detail (P4)
Displaying Setup Menu
1. Set the internal switches of the AT-126 board as
follows.
S1-1
→
ON
S1-2
→
OFF
S1-3
→
ON
S1-4
→
OFF
2. DISP switch (on the side panel)
→
OFF
3. POWER switch (on the camera adaptor)
→
ON
4. Set the DISP switch to MENU (from OFF) while
holding down the MENU SEL switch (on the front
panel). (TOP menu will be displayed.)
n
If the power switch is turned off once, perform the above
operations again to display the setup menu (steps 2 to 4).