Sonifex S0 v2, Руководство пользователя

Страница: 17 / 52

7
User Guide 2
the Program Bus. This button can be disabled via the
Configuration Options, so that it is permanently on
or off.
REC Button
This button allows the output of the channel to
be mixed onto the Record bus output. The button
illuminates red to indicate the channel is active on
the Record Bus. This button can be disabled via the
Configuration Options, so that it is permanently on
or off.
TRIM Control
This control allows the level of the audio on this
channel to be adjusted by ±15dB. This additional gain
is applied prior to the channels fader, and is useful
for setting relative levels between audio sources on
different channels.
Note: It is a good idea to set up all the audio channels
so that they are all at the same reference level when
the fader is fully up, meaning the mix levels are
determined solely by the position of the faders.
PAN/BAL Control
This control has two functions depending on whether
MIC or LINE is selected.
In MIC mode the control acts as PAN and allows the
mono input to be positioned in the stereo image.
With the control in the centre position, the signal is
present on both the left and right channels. Turning
the control fully anti-clockwise pans the signal
to the left by increasing the level by 3dB and the
signal on the right channel is turned off. Turning the
Fig 2-3: Mic/Line
Channel Strip.
control fully clockwise pans the signal to the right
by increasing the level by 3dB. The signal on the left
channel is turned off.
In LINE mode the control acts as BAL (balance) and
is used to alter the stereo image of the stereo input.
With the control in the centre position, the signal is
un-altered. Turning the control fully anti-clockwise
shifts the signal to the left by increasing the gain by
6dB and the signal on the right channel is reduced
by 6dB. Turning the control fully clockwise shifts the
signal to the right by increasing the gain by 6dB while
the signal on the left channel is reduced by 6dB.
CUE PFL Button
Selecting CUE PFL routes the pre-fader input signal
to the monitoring section where the signal can be
heard on the Monitor, Presenter or Guest headphones
(provided that the associated AUTO CUE/PFL button
is selected). The level can then be checked on the
meters
and adjusted via the TRIM control, and the pan
or balance can be set with the PAN/BAL control.
Provided that the fader is closed, the signal will not
be routed to the PGM or REC outputs even if they
are selected. This button is illuminated green to
indicate CUE PFL is active and it has a momentary and
latched action: if the button is held down, CUE PFL
is cancelled when released. There is a Configuration
Option to automatically cancel CUE PFL when the
fader is opened. This option is enabled by default.