39
2. Remove the battery from the device, pull the clip in the middle of the docking station
upwards and insert the battery under the clip. The LED on the docking station shines
orange during charging and green as soon as the battery is fully charged.
Insert the charged battery to the device with the arrow pointing up and front.
Firmware Update
When the DOMINO software is updated, an update of the firmware may be required. This
update will be carried out automatically after accepting the notification. It is necessary for the
SOMNO HD
TM
device to be put into the docking station and left there until the update is fully
completed.
Troubleshooting
Logbook
Code
Description
Short description in
logbook
Further actions at the
device
1
Measurement was finished as
scheduled
Terminated correctly
4
Performance Problem
Performance
Problem
Restart of the device
necessary.
5
Measurement was stopped
due to low battery voltage.
Stopped, low batt.
6
Device cannot access the
memory
card.
Recording
cannot started.
SD-card inaccessible Check orientation oft he
memory
card.
If
orientated
correctly
replace with a different
card.
7
Not enough storage capacity
on memory card.
SD-card full
9
Online
measurement
was
finished in DOMINO. The
device switches off by itself.
Online stopped by PC
11
The device was connected to
the PC while the recording
was running. Recording was
paused. If the pause is too
long
the
recording
is
terminated.
Paused, rec. Missed.
13
Measurement was terminated
manually at the device.
Stopped by user
Only possible with
several manual
confirmations on display
14
The battery was discharged to
fast.
Batt. Worn out
Change battery.
15
Non-programmed or defective
sensor is connected.
Defective sensor
Notification on screen:
Non-programmed or
defective sensor
connected.