SOMFY ROLLIXO RTS, Руководство по установке

Страница: 8 / 64

6 Copyright © 2014 SOMFY ACTIVITES SA. All rights reserved.
EN
Rollixo RTS
3.4 Checking the direction of rotation of the motor and
adjustment of the motor end limits
[1]. Press simultaneously on the and buttons until the motor's up and
down movement occurs to enter motor adjustment mode.
Indicator light 1 ÀDVKHVVORZO\
3 4 2 1
Prog
STOP
[2]. Press button or to check the motor's direction of rotation.
- If the motor's direction of rotation is correct, move on to step [3] of the
motor end limit setting procedure.
- If the direction of rotation is incorrect, press button
STOP
until the motor's
up and down movement occurs, check the motor's direction of rotation
again and move on to step [3] of the motor end limit setting procedure.
Step [3]
3 4 2 1
Prog
STOP
3 4 2 1
Prog
STOP
Correct direction of
rotation
Incorrect direction
of rotation
[3]. If the motor end limits are already set, move on to step [8] to exit motor
adjustment mode.
If the motor end limits are not set, check that the motor is released: the
two push-buttons should be pressed.
Note: The motor end limits can also be set with a setting cable (ref.
9015971). In this case, set the motor end limits with the cable then
move on to step [8] to exit motor adjustment mode.
[4]. Press button to position the garage door in the upper position.
Adjust the top position using buttons and .
3 4 2 1
Prog
STOP
[5]. Press the motor's upper end limit push-button.
or
[6]. Press button to position the garage door in the low position.
Adjust the bottom position using buttons and .
3 4 2 1
Prog
STOP
[7]. Press the motor's low end limit push-button.
or
[8]. Press simultaneously on the and buttons or press the
Prog
button
until the motor's up and down movement occurs to exit motor adjustment
mode.
Indicator light 1 goes out.
3 4 2 1
Prog
STOP
3 4 2 1
Prog
STOP
or
4 - INSTALLING AN OPTICAL RADIO
SAFETY EDGE OR RESISTIVE SAFETY
EDGE WITH XSE TRANSMITTER
4.1 Installing the optical radio or resistive safety edge
and its XSE transmitter
Follow the instructions provided with the XSE transmitter and the optical or
resistive safety edge installation kit.
4.2 Installing a base magnet on the door runner
$EDVHPDJQHWPXVWEH¿WWHGIRUDUHVLVWLYHVDIHW\HGJH
This is VWURQJO\ UHFRPPHQGHG for an optical safety edge. The
presence of a bottom magnet makes it possible to:
- extend the battery life
- eliminate the risk of ground detection, to secure the closing of the
door
- automatically activate the maximum level of sensitivity of the
movement sensor
- increase the sensor operating time by 25 to 35 seconds when the
base magnet is detected.