SOMFY ROLLIXO RTS, Руководство по установке

Страница: 7 / 64

Copyright © 2014 SOMFY ACTIVITES SA. All rights reserved. 5
EN
Rollixo RTS
3 - INSTALLATION
3.1 Mounting the Rollixo receiver
Ensure a suitable distance from the wall socket (2 m power supply
cable supplied).
It is advisable to install the receiver on the same side of the door as
the safety edge transmitter.
[1]. Remove the integrated light bulb.
[2]. Unscrew and remove the receiver cover.
[3]. Mark the drill holes.
[4]. Mount the receiver onto the wall.
[1] [2]
[3] [4]
3.2 Motor and fall protection wiring
The receiver must not be connected to the mains power supply
during connection to the motor.
> Motor wiring
[1]. Connect the motor to the receiver.
Note: the motor's direction of rotation shall then be checked and reversed
if necessary.
L1 L2 N
M
1 2 3 4
Vert/jaune
Bleu
Marron
Noir
[2]. Lock the motor cable with the cable clamp provided.
The motor cable must be placed in the receiver's 230 V insulation
area.
230V insulation zone
24V insulation zone
> Fall protection wiring
The fall protection device must be wired.
Sec
Safety Edge Stop K
5 6 7 8 9 1
3.3 Connecting the receiver to the mains power supply
[1]. Fully unfold the receiver aerial so that it is pointing downwards.
[2]. Screw the bulb supplied into the receiver.
WARNING
An LED bulb of the same type as that supplied (E14 - 1.4W - 230V) must be
used. Using another type of bulb may cause high dangerous overheating.
[3]. Replace and screw in the receiver cover.
[4].
5H¿WWKHLQWHJUDWHGOLJKWLQJEXOE
[5]. Connect the receiver to the mains power supply .
All the indicator lights come on and then go out.
If indicator light 1 comes on permanently, fall protection is not connected
or incorrectly connected to the receiver.
If indicator light 2 comes on permanently, the safety edge has not been
detected by the receiver (radio safety edge transmitter not yet memorised
or the wired safety edge is still not connected).
3 4 2 1
Prog
STOP
[1]
[2]
[3]
[4]
[5]