14
Copyright © 2014 SOMFY ACTIVITES SA. All rights reserved.
EN
Rollixo io
> Memorising by copying a previously memorised 3-button io
remote control
To memorise a 3-button io two-way remote control (Telis io, Impresario Chronis
io, etc.), ensure that the remote control has memorised the system key (see
page 12).
2 s
Remote control memorised
Remote control to be memorised
10 -
0(025,6,1*$1;6(6$)(7<('*(
TRANSMITTER
Memorising a new radio safety edge transmitter overwrites the previous
transmitter.
[1]. Press button
Prog
on the receiver until the indicator light comes on
permanently.
[2]. Using the tip of a pen, press the transmitter PROG push-button for 4
seconds.
Indicator light 2 on the receiver goes out and the receiver Prog
LQGLFDWRU OLJKW ZLOO ÀDVK DQG WKHQ JR RXW WKLV PD\ WDNH D IHZ VHFRQGV
while the transmitter and receiver communicate with each other).
The transmitter is memorised in the receiver.
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
4 s
[1]
[2]
11 - CLEARING THE REMOTE CONTROLS
11.1 Clearing individual buttons on the Keytis io or
Keygo io remote controls
This can be done:
- by memorising via the programming interface.
Memorising a button which has already been memorised will clear this button's
function.
- by clearing directly on the remote control (only on Keytis io remote controls).
Press the "PROG" button and the BUTTON to be cleared on the remote
control together.
11.2 Clearing all remote controls
[1]. Press button
Prog
on the receiver (for approximately 7 seconds) until the
indicator light above it goes out.
[2]. Release button
Prog
on the receiver when the indicator light goes out; the
LQGLFDWRUOLJKWÀDVKHVVORZO\
All memorised remote controls will be cleared.
Prog
Prog
Prog
Prog
Press and hold down for 7 seconds
Prog
12 -
'(/(7,1*$6$)(7<('*(
TRANSMITTER
Note: This operation must be carried out when a radio safety edge is replaced
with a wired safety edge.
[1]. Press button
Prog
on the receiver (for approximately 14 s) until the indicator
light above it goes out.
[2]. Release button
Prog
RQWKHUHFHLYHUGXULQJUDSLGÀDVKLQJRIWKHLQGLFDWRU
OLJKWWKHLQGLFDWRUOLJKWÀDVKHVVORZO\
The safety edge transmitter is cleared.
Prog
Prog
Prog
Prog
Press and hold down for 14 seconds
Prog
Prog
13 - LOCKING/UNLOCKING THE
PROGRAMMING BUTTONS
WARNING
The programming buttons must be locked to ensure user safety. Failure to follow
this instruction may result in serious injury, e.g. due to crushing by the gate.
When the programming buttons are locked, the following functions cannot be
accessed:
- entering programming mode by pressing button
Prog
on the receiver
- entering motor end limit setting mode by pressing buttons and on the
receiver
- setting the operating modes.
To lock the programming buttons, press buttons
STOP
and
Prog
on the receiver
XQWLODOOWKHLQGLFDWRUOLJKWVÀDVK
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
To lock the programming buttons, repeat the locking procedure described
above.
