10
Copyright © 2014 SOMFY ACTIVITES SA. All rights reserved.
EN
Rollixo io
If a wired safety edge replaces a radio safety edge, the radio safety
edge transmitter must be cleared (see section 12) to ensure the
wired safety edge is taken into account.
> Orange LED (part no. 9017842)
'LSVZLWFKUHFHLYHUVHWWR21ĺVHFRQGZDUQLQJDFWLYDWHG
'LSVZLWFKUHFHLYHUVHWWR2))ĺ1RZDUQLQJ
24V dc
24V C
ge
KeySwitch
Flash
9
10
11
12
13
16
17
14
15
4 W max.
> Key lock
Successive presses cause the motor to move (initial position: door closed) as
per the following cycle: open, stop, close, stop, open, etc.
24V
Sec
Safety Edge
KeySwitch
Flash
7
8
9
10
11
12
13
14
1
> Alarm
It is essential to have programmed at least one remote control. The
alarm can only be stopped with a memorised remote control.
• Installing and connecting the alarm
Mount the alarm to the receiver with the bolt provided.
Connect the alarm connector.
• Activating/Deactivating the alarm
To activate/deactivate the alarm, simultaneously press the
STOP
and
buttons
RQWKHUHFHLYHUXQWLOWKHLQGLFDWRUOLJKWVÀDVKUDSLGO\
The alarm emits a beep if it has been activated.
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
• Alarm operation
The alarm is triggered for 2 minutes if the door is raised manually.
No movement of the door is possible when the alarm is sounding.
When the alarm sounds, press a button on a remote control memorised in the
receiver to stop it. The alarm can only be stopped with a memorised remote
control.
• Alarm operation test
%ULHÀ\SUHVVEXWWRQV
STOP
and
on the receiver simultaneously.
7KHDODUPWULJJHUVEULHÀ\WRLQGLFDWHWKDWLWLVDFWLYDWHG
3
4
2
1
Prog
STOP
• Anti-intrusion function test
[1]. Press button to position the garage door in the low position.
[2]. Wait until the transmitter switches to sleep mode (instant if base magnet
installed).
[3]. Manually raise the door by pressing on the rubber.
The alarm is triggered.
[4]. Press a button on a remote control memorised in the receiver to stop the
alarm.
• Optional: lower magnet
$EDVHPDJQHWFDQEH¿WWHGLIWKHDODUPLVWULJJHUHGXQH[SHFWHGO\VHHVHFWLRQ
4.2).
8 - ADVANCED PARAMETER SETTING
8.1 Different operating modes
> 2 operating modes are available:
Sequential (default mode)
Each press on the remote control causes the
motor to move (initial position: door closed)
as per the following cycle: open, stop, close,
stop, open, etc.
Semi-automatic
In semi-automatic mode:
- pressing a button on the remote control
during opening has no effect,
- pressing a button on the remote control
during closing causes it to reopen.
