SOMFY Home motion Dexxo Pro io, Руководство пользователя

Страница: 9 / 76

9
GB
Code Description Comments Action required?
E1 Maximum force reached During learning, the door requires too much force
for the motor. Check door balance and correct operation by
manual operation.
E4 Safety mechanism self test fault The safety device self test failed. Check that “ P2 ” is setup correctly depending on
the devices connected to the safety input.
Check safety device wiring.
When photoelectric cells are used, check their
proper alignment.
E9 Thermal cut out Indicates that the motor has reached its
maximum operating temperature after a number
of continuous cycles. Wait until the motor returns to its normal
operating temperature.
Eb Other faults and failure conditions These codes correspond to various electronic
circuit board failures. Cut the power supply (mains & battery back-up),
wait for a few minutes then re-connect the power
supply.
Perform a learning cycle.
If the fault persists, contact Somfy Technical
Support.
Error and failure codes displayed
Programming codes displayed
Code Description Comments
S0 Awaiting setting:
Motor operating direction for swinging doors Pressing the “ + ” or “ - ” buttons on the keypad will move to S1.
Pressing the “ SET ” button for 2 s starts the learning mode.
S1 Awaiting setting:
Motor operating direction for up and over or
sectional doors Pressing the “ + ” or “ - ” buttons on the keypad will move to S0.
Pressing the “ SET ” button for 2 s starts the learning mode.
S2 Learning mode Pressing the “ OK ” button starts the learning cycle: the S2 display blinks during the entire cycle.
Pressing the “ + ” or “ - ” buttons will control the motor in forced mode.
F0 Awaiting motor control memorisation Pressing a remote control button will assign this button to motor control.
Pressing the “
PROG ” button will call up the “Awaiting remote lighting control memorisation mode: F1 ”.
TROUBLESHOOTING
Operating codes displayed
CCo od dee
Description Comments
C1 Waiting for a command
C2 Door opening
C3 Waiting for the door to close
C4 Door closing
C5 Obstacle detection Displayed during obstacle detection then for 30 s.
C6 Safety input active
Displayed after a movement request or during movement, when the safety input is active.
This display is maintained as long as the safety input is active.
C9 Pedestrian door safety contact active
Displayed after a movement request or during movement, when the pedestrian door contact is open.
The display is maintained as long as the pedestrian door contact remains open.
Ca Safety mechanism self test Displayed during safety mechanism self tests.
Cd
Working from back-up battery
Waiting for a command
5048554A-GB 1/10/07 17:23 Page 9