SOMFY Home motion Dexxo Pro io, Руководство пользователя, Страница: 4 / 76

4
GB
Programming button description
. Press for 2 s: memorise remote controls
. Press for 7 s: delete remote controls
. Press for 0.5 s: call up and exit the setup menu
. Press for 2 s: start learning
. Press for 7 s: clear learning and settings
. Stop learning
. Selecting a setting
. Modifying a setting value
. Using the forced mode
. Start the learning cycle
. Confirm setting selection
. Confirm setting value
Learning
Setting the type of door (Fig. 17).
The motor is already setup to work with up and over or sectional doors (Display “ S1 ”). When the motor drive unit is used with a swinging door,
change the setup by pressing the “ + ” or “ - ” buttons until the “ S0 ” value is displayed.
Learning (Fig. 18).
[1]. Press the “ SET ” button until the light comes on (2 s).
The display shows “ S2 ”.
[2]. Press the “ - ” or “ + ” buttons until the transmission system runner moves to link up with the trolley:
. Pressing and holding the “ - ” button moves the runner in the close direction.
. Pressing and holding the “ + ” button moves the runner in the open direction.
[3]. Press the “ OK ” button to start the learning cycle.
The door moves to the closed position, then performs a complete open and close cycle.
. If learning was correct, the display will show “ C1 ”.
. If the learning cycle was not completed correctly, the display will show “ S0 ” or “ S1 ”.
The learning cycle can be run at any time when the trolley is engaged and the display shows “ S2 ”.
During the learning cycle:
. If the door is moving, pressing any button will stop the movement and interrupt the learning mode.
. If the door is stopped, pressing “
SET ” once will exit the learning mode.
You can call up the learning mode at any time, even when the learning cycle has already been executed and the display shows “ C1 ”.
Programming remote controls
Remote control description (Fig. 19).
Individual control buttons
General
STOP button
General CLOSE button
Operation indicator light On Intermittent Blinking
Low battery indicator light
Closing clip
PROG button: programming the transmitter
KEY button: memorising the system key
Fitting the battery (Fig. 20)

. If the installation already comprises other io-homecontrol® products with at least one programmed remote control then
you must perform the Memorising the system key step before programming the remote controls (Fig. 22).
. If the Keytis io remote control to be programmed is the system’s first remote control, then go straight to Programming the
Keytis remote control step (Fig. 23 to 25).

The operations for memorising the system key and to program a remote control by copying another Keytis remote control are
only possible at the installation location. To gain authorisation to transfer its system key or its programming, the previously
programmed remote control must be able to establish radio communication with an installation receiver.
8
7
6
5
4
3
2
1
Fig. 19 to 25
Figs. 17 and 18
PROGRAMMING
5048554A-GB 1/10/07 17:23 Page 4