Solstice SLS-ENVR Series, Руководство пользователя

Страница: 12 / 71

6
SECTION 2: INSTALLATION AND SETUP
Retaining
screws
Retaining
screws
Control
button
Control
button LED
LAN
connector
USB
connector
Power
connector
Back panel
Use the connectors, indicators and switch on the back of the NVR as follows:
•
Control button LED
: Indicates the usage state of the control button (see table below)
•
Control button
: Pressing the Control button can affect the DVR in three different ways, depending on how long the button
is pressed. Pressing the button for less than 5 seconds signals a “
short
” press, pressing the button for 5 ~ 10 seconds signals
a “ long ” press, pressing the button for more than 15 seconds signals a “ very long ” press. The NVR reacts differently to these
presses depending on the status. See the table below.
Power LED
Information
LED
Status
Short press ( < 5 s)
(Control LED lights)
Long press (5 - 10 s)
(Control LED blinks)
Very long press ( > 15 s)
(Control LED blinks fast)
— — Power supply connect Start Factory reset
—
— — Off Start Start
—
On Off Normal mode Rescue mode Shutdown
Hard shutdown
Off On Rescue mode Normal mode Shutdown
Hard shutdown
Blinking Off Starting
On Blinking
Found by the Discover
utility
On Fast blinking Factory reset in progress
•
LAN connector
: Used to connect an Ethernet cable to the NVR.
•
USB connector : For future use.
•
Power connector : Used to connect the power adapter provided (12 Vdc) to the NVR.
PRELIMINARY