Solidyne 2600 serie, Руководство пользователя

Страница: 9 / 45

5. SOL-TAIL Adapter RJ-45-F to 8 cables (Bare Bone)
ready to weld any type of connector..
2.2 Inputs & Outputs connections
The rear panel contains the connectors for the loud-
speakers monitors, headphones, and telephone
lines with the associate phone sets and the output to
plug the ONAIR light (Tally).
All inputs connectors are located under the rear
panel, using RJ-45 connectors. Remember: good
connections between the console and audio equip-
ment are very important question to guaranty a sure
and free of flaws operation. For that, we recommend
you take the necessary time to carry out the wiring
of the console, with a great care and always using
components of good quality.
A good solution is to acquire the wiring kit Solidyne
SOL45.
Fig.3a Rear panel– connectors
2.2.1 Power source
At left, the console's rear panel have the on/off
switch, the main fuse (1 Amp) and the AC connector
(Interlock power-cord, factory provided). The con-
sole can be used with 110/240 VAC 50/60 Hz, with
automatic selection (switching power source).
Fig.3b Rear panel– power source
2.2.2 MONITOR OUTPUTS
The outputs "STUDIO" and "CONTROL ROOM" are
of line level, designed to be used with powered
speakers. The connectors are TRS 1/4”. The output
level adjusts from Master module with the knobs
“Sudio” and “Control room” respectively.
2.2.3 HEADPHONES
STUDIO and CONTROL ROOM have independent
outputs, using ¼” jacks connectors. The STUDIO
output allows to connect up to 8 headphones. CON-
TROL ROOM output supports up to 2 headphones.
The headphone outputs have protection against ac-
cidental short circuits.
At the console, the operator has independent level
controls for Studio and Control headphones. We
recommend to install at the Studios the Solidyne
Studio Box (optional): a headphones amplifier/mixer.
This unit is placed on the table and manage up to 5
headphones with independent volume controls. In
addition StudioBox offers talk-back to the control
room.
2.2.4 TALLY LIGHT
The STUDIO LIGHT output gives 12V/0,4A when
one or more microphones are on-air. This allows to
connect up to 5 LED’s lights (12V/60mA).
As alternative, the outputs “Starts Devices” can be
used to manage individuals lights for each micro-
phone. The electric circuit is shown in the general
connections diagram (please see the 2.2.2.4).
FUSE: The on-air light is protected by an internal fuse of 1A. If the
fuse blows, you must to remove the rear panel to replace it. This
fuse is located near to the tubular tally connector.
2.2.5 CONNECTING THE PHONE LINES
The Hybrid 2608 manages 2 telephone lines and 1
Bluetooth link for a cell phone.
At the rear panel there are four RJ11 connectors: two
are for telephone lines; two are for connecting the as-
sociated telephone sets (production phones). Once
connected the lines, adjust the rejection factor in or-
der to pair the impedance to the local telephone line
(please refers to 3.3 – Master Module 2608).
The lines can be connected directly to the radio sta-
tion's PBX or directly to the public telephone system.
The hybrid inputs have internal filters for RF rejection,
effective in AM, FM and UHF bands. The telephone
lines have internal high tension protection using Metal
Oxide Varistors. But we recommend having addition-
ally a good external protection.
solidynepro.com Broadcast mixing consoles - 2600 series Page 9