Sole Diesel SM-82, Руководство оператора

Страница: 15 / 56

INSTALLATION
15
Operator’s Manual Marine Diesel Engines
Revision 0. 05/2016
Section 3 – Installation
3.1. Angle of Installation
Make sure the engine is installed on a level surface. Otherwise, the following angular
operation maximum is permitted:
Continuously Temporary
SM-82 / SM-94 15º 25º (Max. 30 min.)
If the engine operates in these conditions, check Section 6.5. Lubrication System.
3.2. Engine installation
Follow these steps to install the engine:
1. FIX ENGINE. See Section 11 Overall Dimensions and Section 9 Tightening torques.
2. ENGINE COUPLING. Couple the motor to the inverter, hydraulic pump, alternator or power
extraction mechanism correctly.
3. CONNECT EXHAUST OUTLET. See Section 11 Overall Dimensions
1. WET EXHAUST OUTLET
2. DRY EXHAUST SEAWATER OUTLET
4. CONNECT SIPHON BREAKER. (if installed) See Section 11 Overall Dimensions
5. CONNECT SEAWATER INLET. See Section 11 Overall Dimensions
6. CONNECT FUEL INLET. See Section 11 Overall Dimensions
7. CONNECT LEAK COOLANT OUTLET. See Section 11 Overall Dimensions
8. FILL WITH OIL. See 6.4 Lubrication System.
9. FILL WITH COOLANT. See 6.6 Cooling System.
10. CHECK EACH PIPE CONNECTION for oil or coolant leaks.
11. PRIME THE FUEL SYSTEM. See 6.5 Fuel System
12. CONNECT TO SVT PANEL. See Section 11 Overall Dimensions
13. CONNECT TO BATTERY. Follow label battery connection into the engine.
It is necessary to install a waterlock (supplied as accessory) in the exhaust system to avoid
water ingestion (See section 6.7).