Sole Diesel 10 GSC, Руководство оператора

Страница: 9 / 120

8
In case of fire do not open sound shield compartment and follow these instructions:
1. Shut down genset(s)
2. Continuously discharge entire contents of a halon or CO
2
portable fire extinguisher (or other
provision) immediately.
There are some aspects that you must
consider:
Obligations:
Operator Manual of genset . Read and
understand it before operating and
servicing the genset to ensure that you
follow safe operating practices and
maintenance procedures.
Grounding electrical equipment . Connect
genset to earth connection.
Hearing protection. Use it to avoid
hearing loss when you operate the
genset.
Fig. 2. Warning label. General precautions
Prohibitions:
Restricted Access. Only authorized personnel can access to genset space.
Do not burn garbage . It is necessary to offload the genset waste in a special place.
Do not smoke or permit flames or sparks to occur near sources of spilled fuel or fuel vapors.
Dangers:
Hazardous voltage . Operate the genset only when all guards and electrical enclosures are in place.
Before working on the genset disconnect it from the load by switching off the line circuit breaker.
Hot parts, coolant and steam . Stop the genset and allow it to cool before touching or removing any
genset part.
Moving parts . Keep hands, feet, hair, clothing and test leads away from the belts and pulleys when the
genset is running. Replace guards, screens and covers before operating the genset.
Before working on the genset or connected equipment, disable
the genset as follows:
(1) Set the genset controller (SCO 10) to OFF Mode.
(2) Disconnect the power input from battery.
(3) Disconnect the battery cables. Remove the negative (-)
lead first when disconnecting the battery. Reconnect the
negative (-) lead last when reconnecting the battery.
Follow these precautions to prevent the starting of the genset
by genset controller (SCO 10), remote start/stop switch, or
engine start command from a remote computer.
Fig. 3. Warning label. Rotating parts