SÓLAS
CONTEMPORARY FIRE
32
SÓLAS ONE-TOUCH REMOTE OPERATION
SÓLAS ONE-TOUCH REMOTE
PAIRING SET-UP
The Control Module and the Remote must be paired
before the first use. This has been completed for you
at the factory. Refer to the section below if the Control
Module and Remote lose synchronization.
1. Insert two AAA alkaline batteries in the Remote. Only
use brand name alkaline batteries, such as Duracell or
Energizer.
2. Four AA alkaline batteries are installed in the Control
Module (shown below).
NOTE: The four AA batteries are only used for battery
backup purposes in the event of a power outage.
3. Locate the RESET button on the front side of the
Control Module.
4. Press and hold the Control Module’s RESET button until
you hear one short beep and one long beep. After the
second beep, release the reset button.
5. Within the subsequent 20 seconds, press and hold
the button on the Remote for 2-3 seconds.
will be displayed and flash on the Remote during the
pairing sequence. The Remote will count up from 1 to
8, and you will hear two short beeps confirming the
pairing is complete.
If you hear one long beep, the pairing sequence has
failed or the wiring is incorrect.
This is a one-time pairing and is not required when
changing the batteries of the Remote or Control Module.
The remote control system is now ready to use.
RESET Button
SÓLAS One-Touch
Module de Controle
Part #S-504
SÓLAS One-Touch
Programmable
Thermostatic Remote
Part #S-507
NOTE: The batteries in your SÓLAS One-Touch
remote control and control module are to be
replaced annually.
