5.0 Setting up the SI7500 (cont.)
502858 issue 1.1
5.0 Setting up the SI7500 (cont.)
15
a) Selecting "Teach" will cause an on-screen message to appear, prompting you to press the OK softkey and then actuate
the relevant module (for a Digital Probe or Linear Encoder, move the probe tip).
If the module input has been successfully read, another on screen message will appear notifying you of the successful
“teaching” of the Orbit module.
b) Selecting "Entry" will bring up the Enter Id screen whereby you can input the Orbit module’s Id (as displayed above the
bar-code on the PIE case, connected to the T-CON).
To enter the Id code, select the desired characters with the cursor keys and use the Enter and Cancel keys to respectively
enter or delete a character. Numerals are written to the address directly from the Numeric keypad. The Id will be displayed
at the top of the screen (underlined in red) as it is written.
Once the complete module Id is displayed at the top of the screen, press the Finish softkey to store the Id and return to
the channel screen. If the module Id has been successfully read, an on-screen message will appear notifying you of the
successful reading of the Orbit module’s information.
Repeat this process until the Id’s of all Orbit modules on the network are assigned to a particular SI7500 input channels.
