SolarEdge OP250-LV, Руководство по установке

Страница: 97 / 122

Inverter User Interface
SolarEdge Installation Guide – MAN-01-00002-1.6
97
5
Select the 5. Communication option to define and configure the
communication option used by the inverter to communicate with the
SolarEdge Monitoring Server.
1 . S e r v e r < L A N >
2 . B u s < Z i g B e e >
3 . L A N C o n f
4 . R S 4 8 5 C o n f < S >
5 . Z I G B E E C o n f < S >
6 . R S 2 3 2 C o n f
7 . M o d b u s C o n f
•
Select option 5.1. Server to select which communication method is used
to communicate between this inverter and the SolarEdge Monitoring
Portal.
•
Select options 5.1.1 , 5.1.2, 5.1.3 or 5.1.4 to configure the communication
method to the SolarEdge Monitoring Portal. Refer to Chapter 6 , Setting
Up Communication on page 66 for a full description of these
communication options:
You can also select the 5.1.5 None option if no server communication is
required.
NOTE:
This menu shows only the actual communication options installed in the
inverter, based on the ordering options selected. If a communication option is
not installed in the inverter, the relevant number does not appear in the menu.
6
Select the 6. Counters option to reset all telemetry counters that are
displayed in the Energy Meter window, which is described in the Energy
Meter Window section on page 86.
T h i s a c t i o n w i l l
R e s e t a l l c o u n t e r s
P l e a s e S e l e c t : N O
7
Select the 7. Phase Balance option to enable/disable the inverter’s power
balancing option, which enables the connection of three single-phase
inverters to a three-phase grid. The power balancing feature requires a power
balancing hardware add-on module that can be acquired at SolarEdge.
8
Select the 8. Info option to display the Printed Circuit Board ID and the
inverter’s firmware version numbers.
9
Select the 9. Factory Reset option to perform a general reset of the inverter
to its default settings.