4.
At the back of the heater, remove the plate holding the terminal box by removing the two
fixing screws as shown in Fig. H.
5.
Pull the emitter wires one at a time through the plate to remove as shown in Fig. J.
6.
At the front of the heater, remove the grille bridging clamps as shown in Fig. K from both
sides of the grille by undoing the centre screws and then remove the grille by pulling it out
from the centre and prizing the prongs away from their locating holes at one end of the grille
(Fig. L) and pull out of opposite end.
Fig. H
Fig. J
FIXING SCREWS
10
7.
Remove the screws from the middle reflector on both sides (Fig. M) and the single screw
from the side reflector (Fig. N). Lift them up and away from the heater to reveal the ceramic
caps on the lamp emitters.
Fig. N
Fig. M
SCREW
Fig. K
SCREW
Fig. L