12.
Refit the grilles by taking a grille
and inserting the 2 × prongs into the
holes in the end of the heater (left
side shown below in Fig. S) and
gently flex the wire grille to insert the
2 × opposite prongs into the grille
holder holes (to the other side of the
lamp emitter as shown in Fig. T).
13.
When fitting the middle grille,
insert the 2 × prongs into the holes in
the grille holder (Fig. U) and gently
flex the grille to insert the 2 × opposite
prongs into the opposite grille holder
holes as shown in Fig. V.
Fig. S
Fig. T
Fig. U
Fig. V
14.
Refit the grille bridging pieces over the grille prongs as shown in Fig. W at the ends of
the grilles.
15.
Check the fitment of the grille by individually gripping them and moving them to their
extreme left and right positions/pushing up and down to ensure they are all securely located
(Fig. X).
Fig. W
Fig. X
12