Solahart 151J, Руководство пользователя

Страница: 28 / 60

INSTALLATION INSTRUCTIONS - ALL MODELS
28
FITTING THE PIPE SHROUD COVER
The Pipe Shroud Cover contains a number of preformed cut outs.
•
Each cut-out can be removed using a pair of snips
by following the preformed cut-out lines.
•
Remove only the necessary cut-outs to suit the
installation.
•
Caution: Practise safe working procedures when
using the snips and care is to be taken to avoid
potential injury from cut edges.
•
Additional cut outs other than those moulded into
the cover should not be made.
To fit the Pipe Shroud Cover to the jacket end after the
plumbing pipe work and electrical connection has been
made:
•
Position the cover so the five connection points
line up over the five screw penetrations in the tank
end cover.
•
Screw in the five screws provided, taking care not
to over tighten the screws.
Only use the screws provided.
Note: The Pipe Shroud Cover when fitted must be flush with the jacket end of the solar storage tank. There is to be no
distortion of the cover due to poorly installed pipe work. Correct the pipe work if the cover does not fit correctly.
To Turn Off The Water Heater
If it is necessary to turn off the water heater on completion of the installation, such as on a building site or where the
premises is vacant, then:
•
Ensure the collectors are covered with an opaque material,
•
Switch off the electrical supply at the water heater isolating switch(s) on the switchboard and at the isolating switch(s)
at the solar storage tank(s) (if installed),
•
Close the cold water isolation valve at the inlet to the water heater(s) to shut down the entire system, or;
•
Close the isolation valves on the cold and hot water branches to shut down an individual water heater in a bank.
OTP
Expansion
vessel flexible
hose cut out
pipe work
cut outs
electrical and
pipe work
cut out
additional
pipe work
cut outs