7
Unscrew the corresponding bolt on the other side plate and
remove the required suspension element. If the full dismantling
of the suspension is necessary, remove all the bolts of the second
side plate and disassemble the suspension into components and
parts�
6.5 Assembling the suspension
To assemble, lay out all the suspension elements and fasten
them with bolts with one of the side plates by snugging up only
by half.
Put the track on the edge and insert the assembled suspension
inside. Then fasten the second side plate. Connect the
suspension to the frame and tighten the fixing bolts.
Set the chain.
!
WARNING
WHEN TIGHTENING ALL THE SUSPENSION BOLTS
AND THE BOLTS HOLDING SUSPENSION TO THE
BODY, USE THE ANAEROBIC THREAD LOCKER.
Tighten all the bolts holding the suspension to side plates with
the torque indicated in Table
5.1 on page 5
�
6.6 Suspension bogies
The SNOWDOG suspension is based on bogies, two or three
depending on the model. Rubber wheel rollers fail when operated
with high loads, colliding with obstacles and storing under the
load. When springs wear out, SNOWDOG sags, becomes softer,
the range of the track adjuster is insufficient to ensure tension.
The worn-out spring should be replaced. The bogie springs differ
by the direction of winding.
Bogie setup:
1� Rubber roller rim
2�
Bolt М8
3�
Roller balancer axis
4�
Bushing
5�
Right roller spring
6�
Left roller spring
7� Roller balancer
8�
Internal cheek
9�
External cheek
10�
Plug
11�
Plug of roller rim
12�
Self-locking nut 6 DIN 985
13� Internal roller balancer
14�
Bolt 6x20 DIN 933
15�
Bearing 205
16�
Washer 10 DIN 125
