11
Installing your Snooper Evolution using the Hook and Loop
fastener
The Snooper Evolution can be installed anywhere on the dashboard as long
as the built in GPS antenna has a clear view of the sky and you can easily
see the LED text display and operate the controls safely. You will also need to
be sure that you can connect the power connection cable. Your Evolution can
be installed easily with the hook and loop fastener if you have a sufficiently
flat area on your dashboard.
Follow these instructions to mount the unit in this way.
•
Use an alcohol wipe or similar cleaner to thoroughly clean the bottom of the
Evolution and the area of the dashboard where you intend to mount your unit.
•
With the two parts of the Hook and Loop fastener still fastened together,
peel the backing tape from the softer ‘Loop’ side of the fastener and apply
it to the bottom of the unit.
•
Next remove the backing tape from the ‘Hook’ side of the fastener, again
whilst the two parts are still fastened and position the unit onto the desired
area. If possible leave the Hook and Loop fastener for 24 hours to adhere
properly before using regularly.
The Evolution is supplied with two power cables one of which can be
connected to the vehicles cigarette lighter socket as follows.
•
Connect the smaller right angled plug to the socket marked ‘DC 12V’ on
the
Evolution.
•
Push the cigarette lighter plug firmly into the vehicles cigarette lighter
socket. (For the hardwire instructions please refer to the relevant section.)
•
The Snooper Evolution is now ready for use.
Installing the Evolution
Installing the Evolution
Return to contents
