19
1.
From target torque screen, use
UP/DOWN
buttons to set target torque and
UNITS
button to select
torque measurement units then press
ENTER
button.
2.
Angle target screen is displayed. Use
UP/DOWN
buttons to set target angle then press
ENTER
button.
3.
Torque THEN Angle mode screen is displayed.
4.
Apply torque until target is reached then rotate wrench to target angle.
Note:
UNITS
button can be used to select torque units while on Torque THEN Angle screen.
Note: Torque cycle is not recorded in memory unless both torque and angle reach targets.
Note: Red progress lights turn on if torque exceeds 110% of wrench full scale or if angle exceeds target
+ plus tolerance while in manual mode.
Note: Torque THEN Angle Presets are entered by pressing and holding Units button while on Torque
THEN Angle screen. MAXIMUM TORQUE defaults to full range plus 10%. Refer to "Adding a
Torque Preset" and "Adding an Angle Preset" in Basic section for parameter entry.
Enable/Disable Torque AND Angle Mode
This function will allow user to enable or disable Torque AND Mode.
1.
From Mode Setup menu, use
UP/DOWN
buttons to highlight
AND DISABLED
(factory default)
selection then press
ENTER
button.
2.
TQ AND ANGLE enable/disable screen is displayed.
3.
Use
UP/DOWN
buttons to select ENABLE or DISABLE selection.
4.
Press
ENTER
button to accept selection and exit to Mode Setup menu.
Note: Menu selection indicates current configuration (ENABLED or DISABLED).
00
100.0
IN-LB
ENTER
button
ENTER
button
UP/DOWN
buttons
00
45°
00
TQ: 100.0 IN-LB
THEN ANG: 45°
UP/DOWN
buttons
UP/DOWN
buttons
ENTER
button
ENTER
button
UP/DOWN
buttons
EXIT
TQ-% SETUP
TQ+% SETUP
TQ+% SETUP
THEN DISABLED
AND DISABLED
TQ AND ANGLE
ENABLE
DISABLE
TQ+% SETUP
THEN DISABLED
AND DISABLED
TQ AND ANGLE
ENABLE
DISABLE
TQ+% SETUP
THEN DISABLED
AND ENABLED
Содержание ControlTech Micro
Страница 35: ...34 ...