ZINGO X-012
© SMP (PLAYGROUNDS) LTD, TEN ACRE LANE, THORPE, EGHAM, SURREY, TW20 8RJ
Page 30
NOTE: See “Appendix A Note 2” for assembly of Plastic Slide and relevant components.
30) Assemble Slide Feet (items 16 & 17) to underside of Slide (item 15) and secure using 2 off M10 x 16 Hex. Bolt
(item 56) and Heavy Duty Washers (item 58). See FIG.41.
31) Offer Slide (item 15) up to Entry Frame (item 8) ensuring the top of the slide rests on the cross member. The
walls of the slide must be positioned outside of the gussets on the entry frame.
32) Shim under the slide legs to set the slide plumb and square adjust the slide exit to the required height. See
FIG.43.
33) Secure the slide to the gussets using 2 off M6 x 10 Resistorx bolts (item 55) and M6 Nyloc nuts (item 65). The
Resistorx bolts heads must be on the inside of the slide. See FIG.42.
NOTE:
The slide runout should taper towards the ground at a angle of 1.5° max. to allow a watershed.
NOTE:
It is very important to check the slide run out section does
not
hold water after installation. It is
recommended that an actual test be carried out, on site, prior to concreting the slide into its final position.
Should any deformation to the run out section have occurred during transportation and storage this must be
corrected prior to final installation.
FIG.41
FIG.42
FIG.43
58
56
55
65
15
17
16
MAX HT O
V
ER SLI
D
E = 200mm
MIN GAP UNDER SLIDE = 25mm
F.S.L.
ISSUE B
Содержание ZINGO MAGIA X-012/P
Страница 2: ...INTENTIONALLY LEFT BLANK ...
