15
Assembly
Hardware needed:
x4
Insert ignition wire on the middle burner onto the pin on the
piezo igniter pre-assembled on the control panel assembly.
(Fig.14A)
and
(Fig.14B)
Insert side burner ignition wire to pin on piezo igniter pre-
assembled on control panel assembly as shown.
(Fig. 14C)
Place the control panel assembly onto the 3 burner tube
valves sticking out the front of the gas cabinet. You MUST
make sure that tip of the (3) valves go completely INSIDE
each opening of the burner tubes
(Fig. 14D)
.
Then attach the control panel assembly to the gas cabinet
using (4) M6x12 bolts from INSIDE of the cabinet as shown
(Fig. 14E)
and
(Fig. 14F)
Fig.14D
Valve tip
Burner
Tube
Fig. 14E
13
Assembly
Fig. 10C
Step 10
Fig. 10B
Step 10: Assemble Control
Panel
As-
sembly (Continued)
Procedure:
Place the Control Panel Assembly
onto the Valves. You
MUST
make sure that the
tip of the valve is completely
INSIDE
the end
opening of the Burner Tube as shown as 10B.
Attach the Control Panel Assembly to the Gas
Cabinet using (4) M6x12 bolts from INSIDE of
the cabinet as shown as Fig. 10C and Fig. 10D.
Fig. 10D
Fig. 14F
Fig. 14A
Fig.14B
Fig. 14C
Side Burner Ignition Wire
14
Attach Control Panel Assembly
A
5
25
A
A
A
A
