Smiths Medical Oxi-Pulse 30, Руководство по эксплуатации для домашнего использования

Страница: 20 / 66

Chapter 3: Getting Started
3-2 Home Use Operation Manual
Home Use Caregiver - What you Should know
You (the home use caregiver) must be trained in CPR. Make sure the monitor’s alarm limits and
other settings are properly adjusted. Confirm that the monitor is in the Home Mode. Follow the
guide below and be sure you know how to do all of the following.
WARnInG! The monitor was not designed or tested to be an apnea monitor.
Connect the AC Power Supply to a wall outlet. •
Make sure the AC Power Supply outlet is not controlled by a wall switch. •
Connect AC Power Supply to the docking station or oximeter. •
Make sure the monitor’s POWER indicator is lit. •
Visually inspect the sensor and oximetry cable. •
Connect the sensor to the oximetry cable. •
Connect the oximetry cable to the monitor. •
Turn on the monitor. •
Perform a pre-use check: Verify all display LEDs turn on and the monitor beeps at power •
up.
Route the cable safely from the patient to the monitor to prevent possible patient •
strangulation.
Attach the sensor(s) prescribed by the doctor. •
Measure the SpO •
2
, pulse rate, PI and pulse strength bar graph readings.
Turn off the alarm and alert tones for two minutes. •
Turn on the alarm and alert tones. •
Interpret the alarms. •
View the alarm limits. •
Interpret the alerts. •
Interpret the Low Battery Signal. •
Turn off the monitor if appropriate. •
You should know how to respond:
In case of a patient emergency, including what therapy to provide the patient. •
In case an alarm sounds, including what therapy to provide the patient. •
In case the alert sounds. •
In case the Low Battery Signal sounds. •
In case you have trouble operating the equipment. •