WD3060 - WD5090
USER MANUAL
32
Without pressing the tabs, lift the entire unit (D).
When cleaning this filter, it is best also to clean the others.
Recommendations for correct maintenance
The filters should be cleaned under running water using a stiff brush.
It is essential to clean the filters carefully in accordance with the instructions given above: the appliance washer
will be unable to operate correctly if the filters are fouled.
Fit the filters back in place with care before starting a washing program.
13.2
DRYING AIR FILTER - only if present
The
air filter
of the drying system must be periodically checked and changed.
It is installed in the lower part of the
detergent compartment.
The mat filter installed possesses 98% DOP efficiency and should be
replaced at least once a year.
This operation is simple to do and the user can carry it out on his own after ordering the spare filter.
Unscrew the screw that holds the filter in place in order to disassemble the filter holder and install the new filter.
The ABSOLUTE 99.99% DOP (HEPA) filter is installed under the 98% DOP filter.
The filter remains efficient until it fully clogs, something that occurs progressively, thus reducing the volume of drying
air. It is advisable to replace the first stage once a year and to visually check to see how much the second filter has
darkened at this time.
The appliance will warn when the absolute filter needs replacing.
A clogged filter contributes to the degradation of the drying performance.
13.3
IF THE DEVICE IS TO BE OUT OF USE
If the appliance is to be left unused for a long time, follow these recommendations.
The procedure is recommended for
periods of 24 hours or more out of use.
Perform the PREWASH program
with the appliance empty (without load in the washing chamber).
If contaminated materials are processed: run a program with a thermal disinfection Td phase
with no load in
the appliance.
Disconnect the electricity supply.
Leave the door slightly open to prevent unpleasant odours from forming inside the washing chamber.
Turn off the water intake tap.
13.4
REUSING THE DEVICE AFTER A PERIOD OUT OF USE
If the appliance has been unused for a long time, before starting a cycle, follow these recommendations.
Inspect the filters at the ends of the water intake hoses and check that no sludge or rust has deposited in the
pipelines; if this has occurred, allow water to run from the water supply tap for a few minutes.
Restore the electricity supply (if disconnected).
Reconnect the water supply hose and turn on the tap.
Run a program with a thermal disinfection phase with no load for processing.
A thermal disinfection cycle should be performed before using the device if it has been out of use for 24
hours or more.
