WD3060 - WD5090
USER MANUAL
16
7.6
PRINTING OUT THE LAST CYCLE PERFORMED
N.B.: the printer is an optional and not part of the standard equipment.
The last cycle performed can be printed out with the device in standby mode. Proceed as follows:
Press
STOP
with the screen of the last cycle performed on the display.
The print confirmation prompt screen appears: press
ENTER
to confirm or
ESC
to abort.
PR:
PLASTIC 70°C + Dry
(000003)
Phases N.:
5
Duration:
1:10:00
<Drying On>
05/02/2013 08:30:15
Fig. 10 - screen of the last program performed
PRINT LAST CYCLE?
< YES >
Fig.
11
- printout confirmation screen.
7.7
POSTPONING THE CYCLE START
Maximum delay setting: 10 hours. To postpone the start of a cycle:
press
INC
with the screen of the cycle selected on the display.
The delay time setting screen appears;
Set the delay time using the
R
and
L
selector buttons to locate the cursor on the hours and minutes and the
INC
and
DEC
buttons to increase or decrease the value.
PR:
3 PLASTIC 70°C + As
(000003)
Phases N.:
5
Duration:
1:10:00
<Drying On>
05/02/2013 08:30:15
Fig.
12
- screen of the last program performed
PR: postponed
3 PLASTIC 70°C
Type delay
Hours 00 Min 00
05/02/2013 08:30:15
Fig.
13
- postponed start setting screen.
7.8
SECURITY POLICY, USER AND SUPER USER PASSWORDS
For safety reasons, the device implements
a protection policy with four password levels
that enable or deny access to
the menus of the appliance.
user level
: concerns the people who actually operate the machine (nurses, assistants, department heads). This
password enables access to the “program selection” and “change password” menus only.
super user level
: concerns the person in charge of the machine (department head, clinical engineer, etc.). This
password can be used to access the following menus:
o
PROGRAMMING: Loading Programs;
