User instructions
PROGRAM DELAY
The
PROGRAM DELAY
button can be pressed to delay the start of the
washing program by from
1 to 12/24
hours depending on the model. This
option allows the dishwasher to be operated at the time of day of the user's
choice. The first time the
PROGRAM DELAY
buttonis pressed the
option light comes on and 1:h appears on the
DISPLAY.
The button can
then be pressed again, to set the delay required (
2:h, 3:h
,
… etc.). If no
button is pressed for a few seconds, the
DISPLAY
shows the time left (time
remaining) to the end of the selected program (e.g.
5:40
, duration of the
washing cycle + program delay). When the user confirms the program start
(read the relative section) a prewash will be carried out, after which the
PROGRAM DELAY
set will begin, and the time remaining on the
DISPLAY
will gradually be counted down. At the end of the delay set, the option light
goes out and the washing cycle starts.
N.B.:
It is not poss ible to select the
PROGRAM DELAY
option once the
cycle has begun.
Chosen the delay, proceed with the program start, press the
button
START/PAUSE
for same seconds until the
START/PAUSE
symbol start to flash.
The machine will perform a dish pre-washing, and when finish
, the “delay
program” will enter in function as it was first set.
In case you w
ant to put to zero the “delay program” within the running
program it is necessary:
•
to press the
START/PAUSE
button for some seconds until
the
START/PAUSE (D)
symbol remain lid up on the display;
•
to press the
DELAY PROGRAM
more times until the reset of the
delay program (
START/PAUSE
symbol shut off);
•
to press the
START/PAUSE
button to make start the program.
N.B.:
It is not possible to select the
“
delay program
” when the program
have already began.
16
