x
Turn on the burner and put it on the minimum position. Pull out the knob of the gas tap and work on the regulation
screw of the rod tap side, until you get a minimum flame adjust.
x
Put back the knob and verify the stability of the burner flame (rotating rapidly the knob from the maximum position
to that of minimum, the flame should not extinct.) Repeat the operation on all the gas taps
For liquid gas (GPL or G30).
•
For the regulation of the minimum position with liquid gas you will need to screw completely in clockwise sense
the screw located on the rod of the tap side.
•
The by-pass diameters for each one of the burner are showed in the table
"Burners and Injectors
Characteristics "
of the instruction manual
.
When the regulation has been done, put back the seal on the by-pass using painting or equivalent materials.
Screwdriver insertion zone, for the regulation of the
minimum position in hob cooking burners.
- Adjustment of the gas oven/grill burner's primary air
• Loosen the adjusting screw "
A
" of the air
adjustment pipe coupling.
• Turn the adjusting pipe coupling "
B
" in the
corresponding position according to the gas type to
be used (see the chart below).
• Tighten the adjusting screw and recover the
sealings.
• Once the operation ends, properly assemble the the
burner
METHANE (N)
G30/G31 (GPL)
G 110 – GAS CITY
X =
5 mm
15 mm
3 mm
11. Troubleshootings
The aim of this paragraph is to make a list of an immediate solution to the possible complaints /faults which can be
posed by the users.
Complaint/Effect
x
the hob/oven burner flame switches off or does not stay switched on
Causes
•
Hob/oven thermocouples faulty;
•
Hob/oven thermocouples not properly fitted
•
Lack of pressure on the tap/thermostat knob (right value 2,4¸ 2,7kg for the hob taps);
31
