Specific Product Precautions 1
Be sure to read this before handling the products.
EX430
Series
Design / Selection
Warning
1. Do not use beyond the specification range.
Using beyond the specification range may result in a fire, mal-
function, or damage to the system.
Check the specifications before operation.
2. When using for an interlock circuit:
• Provide a multiple interlock system which is oper-
ated by another system (such as a mechanical pr-
otection function).
• Perform an inspection to confirm that it is working
properly.
Failure to do so may result in possible injuries due to mal-
function.
Caution
1. Use within the specified voltage range.
Using beyond the specified voltage range is likely to cause
product damage or malfunction.
2. Do not install in places where it can be used as a
foothold.
Applying any excessive load such as stepping on the product
by mistake or placing a foot on it will cause it to break.
3. Keep the surrounding space free for maintenance.
When designing a system, take into consideration the amount
of free space needed to perform maintenance.
4. Beware of inrush currents when the power supply
is turned on.
Some connected loads can apply an initial charge current
which will trigger the over current protection function, causing
the product to malfunction.
Mounting
Caution
1. When handling and assembling products:
• Do not apply excessive force to the product
when disassembling.
The connecting parts of the product are firmly joined with
seals.
• When joining units, take care not to get your fin-
gers caught between the products.
Injury may result.
2. Do not drop, bump, or apply excessive impact to
the product.
Doing so may result in damage, equipment failure, or malfunc-
tion.
Mounting
Caution
3. Observe the tightening torque range.
Tightening outside of the allowable torque range will likely
damage the screw.
IP69K cannot be guaranteed if the screws are not tightened to
the specified torque.
4. When lifting a large solenoid valve manifold, take
care to avoid causing stress to the valve connection
joint.
The connection parts of the product may be damaged.
Because the product may be heavy, carrying and installation
should be performed by more than one operator to avoid
strain or injury.
5. When installing the product, mount it on a flat sur-
face.
Torsion in the whole product may lead to problems such as air
leakage or contact failure.
Wiring
Caution
1. Avoid repeatedly bending or stretching the cable
and applying heavy objects or force to it.
Wiring where repeated bending and tensile stress are applied
to the cable may result in circuit breakage.
2. Avoid miswiring.
If miswired, there is a danger of malfunction or damage to the
product.
3. Do not wire while energizing the product.
There is a danger of malfunction or damage to the product or
input/output device.
4. Avoid wiring the power line and high-voltage line in
parallel.
Signal line noise or surge from the power line or high-pressure
line could cause a malfunction.
Wiring of the product or input/output device and the power line
or high-voltage line should be separated from each other.
5. Check the wiring insulation.
Defective insulation (contact with other circuits, improper insu-
lation between terminals, etc.) may cause damage to the
product or input/output device due to excessive voltage or cur-
rent.
38
JSY5000-H
V
alve
Sub-plate
Manif
old
Exploded Vie
w
Sub-plate
Exploded Vie
w
Fittings,
Plugs,
Tube
Releasing T
ools
Manif
old
Options
Specific Pr
oduct
Precautions
Made to Or
der
EX430