HGM6100U Series Automatic Control Module
HGM6100U Automatic Genset Controller ISSUE 2014-10-28 Version 1.2 Page 11 of 39
3) When
“
Stop Delay
”
is over, genset enters into
“
Cooling Delay
”
. Closing relay is
disconnected. After switch
“Transfer Rest Delay”,
closing relay is outputting, mains is
taking load, generator indicator eliminates while mains indicator illuminates.
4) When entering
“Stop Idle Delay”
, idle relay is energized to output. (If configured).
5) When entering
“
ETS Delay
”
, ETS relay is energized to output, fuel relay output is
disconnected.
6) When entering
“Genset at Rest”
, genset will automatically judge if it has stopped.
7) When genset has stopped, enter into standby mode; if genset failed to stop,
controller will
alarm (“
Fail to Stop
”
alarm will be displayed in LCD).
