Smartgen HAT553V, Руководство пользователя

Страница: 11 / 32

HAT553V ATS Controller User Manual Page 11 of 32
Table 9 B Power Voltage Status
No. Item Description
1 B Available Delay for B power available detection
2 B Unavailable Delay for B power unavailable detection
3 Power Normal Power value is within normal range.
4 Blackout Voltage is 0.
5 Over Volt Voltage is above the pre-set upper limit.
6 Under Volt Voltage is less than the pre-set lower limit.
7 Over Frequency Frequency is above the pre-set upper limit.
8 Low Frequency Frequency is less than the pre-set lower limit.
9 Loss Phase One or two phases are lost among L1, L2, L3.
10 Phase Wrong Phase sequence is wrong for L1-L2-L3.
Table 10 Genset Status
No. Item Description
1 Genset Start Delay Delay time before genset start
2 Genset Stop Delay Delay time before genset stop
3 Schedule Work
Lasting time for scheduled start is displayed when scheduled start is
active.
4 Genset Working Genset start signal outputs.
5 Genset Standby None genset start signal outputs.
Table 11 Switch Status
No. Item Description
1 Ready to Transfer Enter switch transfer procedure
2 Closing A A power is experiencing close delay.
3 Opening A A power is experiencing open delay.
4 Closing B B power is experiencing close delay.
5 Opening B B power is experiencing open delay.
6 Transfer Rest The interval time for switch transfer
7 Closing A Again Again close time when A power failed to open for the first time, if
Again Close Delay is not set to 0.
8 Opening A Again Again open time when A power failed to close for the first time, if
Again Close Delay is not set to 0.
9 Closing B Again Again close time when B power failed to open for the first time, if
Again Close Delay is not set to 0.
10 Opening B Again Again open time when B power failed to close for the first time, if
Again Close Delay is not set to 0.
11 A On Load A power is closed and A power takes the load.
12 B On Load B power is closed and B power takes the load.
13 Offload Switch has been open and load is disconnected.