APPENDIX B
MANAGING THE DISPLAY USING RS-232
71
To increase or decrease the value of a setting
Use the
set
command to increase or decrease the value by a designated number.
This example increases the volume by 5:
>set 5
volume=70
>
This example decreases the volume by 15:
>set volume-15
volume=55
>
Power state commands
Get command
Set command
Response
get powerstate
set powerstate
[Value]
Where
[Value]
is one of the following:
l
=on
l
=ready
l
=standby
NOTE
If the display is in UPDATEON or
UPDATEREADY state, it might not
change power states after receiving
the command.
powerstate=
[Value]
Where
[Value]
is one of the following:
l
on
l
ready
l
standby
l
update
