SMART Rear Projection SMART Board 1800, Руководство по установке

Страница: 44 / 62

RPSB 1800/1802 Installation Guide
38
Image Side-to-Side Adjustment
Tighten the screws that secure the top of the platform when the correct position is achieved.
Tilt the projector platform to make the image level.
Use the zoom lens or move projector to expand/contract the image.
1. Use the projector's zoom lens to adjust image size. Zooming in or out may be
sufficient to expand or contract the square of light to fill the SMART Board.
Move projector on platform
or use projector zoom
Image Size Adjustment
Move projector on platform
or use projector zoom
Image Size Adjustment
KEYSTONING NOTES :
• If the image is keystoned along the sides − that is, the side margins are different
widths (see the figure on the next page)
−
you may need to raise or lower the front
or back of the projector slightly.
•
If the image is keystoned along the top or bottom (the sides of the image are not
of equal length), the projector is not positioned properly at a right angle to the
small front mirror. You may need to move only the back of the projector side to
side to correct the image.
2. You may be able to make minute adjustments to the projector’s position with the
projector’s built-in software, using a remote control or buttons on the projector. Refer
to your projector’s manual for details.
3. Repeat the procedures described above as necessary.
- Loosen both knobs
- Tilt platform
- Tighten both knobs
to maintain new position
Roll Adjustment