16
SMART LightRaise Installation and User's Guide
3
Align the top edge of the template tool with the marks made in step 2. The notched edge
of the template tool must be down. Also align the template tool's centerline hole and
centerline notch with the centerline drawn in step 1.
Use the bubble level to ensure the template tool is level. This is important because the
mounting locations for the boom brackets are established from the console bracket.
Floor
Centerline
Align the top edge
of the template tool
with the marks on
the wall
Template Tool
Centerline Hole
Keyhole Locations for Console
Centerline Notch
4
Use the pencil to mark the two keyhole locations on the wall using the template tool as a
stencil.
To mount the console bracket on a concrete or cinder block wall:
1
Use the supplied
3
/
16
" masonry drill bit with your electric drill to drill a hole at the two
keyhole locations marked in the previous procedure.
2
Partially thread a concrete screw into both hole locations, leaving ¼"
(6 mm)
of the screw
exposed.
3
Hang the console bracket on these two screws, pushing the keyholes firmly down over the
protruding screws. Tighten the screws, but don't overtighten them.
4
Use the bubble level to check that the console bracket is level. This is important because
the mounting locations for the boom brackets are established from the console bracket.
5
Drill holes for the two outer holes. Insert concrete screws into each hole. Don't overtighten
these screws.
6
Drill three holes along the top rows of slots and three along the bottom rows. These holes
should be evenly spaced along the width of the bracket. Insert a screw into each hole (for
a total of six screws in the slots), being careful not to overtighten each.
