SMART 6806800K30J, Инструкция по установке и использованию

Страница: 15 / 50

Safety Notes
RTM-ATCA-F125 Installation and Use (6806800K30J) 15
isolation from the exposed OSP cabling. The addition of primary protectors is not sufficient
protection in order to connect these interfaces metallically to OSP wiring. The intra-building
port(s) of the equipment or subassembly must use shielded intra-building cabling/wiring
that is grounded at both ends.
Operation
Damage of the RTM
High humidity and condensation on the RTM surface causes short circuits.
Do not operate the RTM outside the specified environmental limits. Make sure the RTM is
completely dry and there is no moisture on any surface before applying power.
Environment
Always dispose of used blades, system components and RTMs according to your country’s
legislation and manufacturer’s instructions.
SFP/SFP+ Modules
Personal Injury and Damage of the RTM and SFP/SFP+ Modules
Installing and using SFP/SFP+ modules which are not fully certified and which do not meet
all relevant safety standards may damage the RTM and the SFP/SFP+ modules and may
lead to personal injury.
Only use and install SFP/SFP+ modules which are fully certified and which meet all
relevant safety standards.
Personal Injury
Optical SFP/SFP+ modules may be classified as laser products. When installing and using
any of these SFP/SFP+ modules, the regulations which correspond to the respective laser
class apply to the whole RTM. Not complying to these regulations may lead to personal
injury.
When installing and using optical SFP/SFP+ modules which are classified as laser
products, make sure to comply to the respective regulations.
Eye Damage
Optical SFP/SFP+ modules may emit laser radiation when no cable is connected. This
laser radiation is harmful to your eyes.
Do not look into the optical lens at any time.