SMART 6806800K30J, Инструкция по установке и использованию

Страница: 30 / 50

30 RTM-ATCA-F125 Installation and Use (6806800K30J)
Hardware Preparation and Installation
Hardware Preparation and Installation
7. Fully insert the blade and lock it to the shelf by squeezing the lever and the latch
together and turning the handles towards the face plate.
8. Tighten the face plate screws which secure the RTM to the shelf.
9. If the front blade has already been installed (as in step 2), activate the front blade by
squeezing its lower lever and latch together and press it back into the face plate.
10. If the front blade has not been installed, proceed with the installation instructions in the
front blade installation and use manual.
When the RTM's blue LED is switched OFF and the green LED "OK" is switched
ON, this indicates that the RTM’s payload has been powered up and that the RTM
is active.
11. Connect cables to the face plate, if applicable.
Make sure that the handles of both the RTM and the front blade are closed in order
to power up the blade and RTM payload.