Sleipner VECTOR FINS VF650, Руководство по установке, Страница: 63 / 68

63
5251 5 2022
-
SPS-B
MG_0266
Keel
1
2 3
4 5
6 7 - 9
Off
Port
MC_0256
Installation Checklist
Start-up checks Actuators
�.......... Actuator Manual Decouple Valve Tight.
�.......... Check Electric operated decouple valve (coil nut) is tightened Under 6.8-9.5 Nm.
�.......... Check hose spec from combiner to fi n valve(Less than 2.5m)(Recommended).
�.......... Actuator Hose Connections Tight/Clear Port/Stb.
�.......... Hoses have full range of movement. *excluding SPS-B 55
�.......... Cylinder rods clean, and without damages/scratches .
�.......... Actuator Electrical Connections Clear.
�.......... Actuator Encoder Belt, Wheels ok and Belt Tight.
�.......... Actuator Bonded to the boats electrical system.
�.......... Actuators clear of Boat Structure.
Start-up checks Fin valve unit
�.......... Fin Valve Manual Decouple Valve Tight.
�.......... Fin Valve Check Hose Connections Port/Stb.
�.......... Fin Valve Electrical Connections Correct.
Start-up checks Accumulator block
�.......... Accumulator Block Manual Decouple Valve Tight.
�.......... Accumulator Block Hose Connections Ok.
�.......... Accumulator Block Electrical Connections Correct.
�.......... Accumulator Pressure Transmitter Reading Correct.
Start-up checks Electrical components
�.......... Check Power Feed is Active.
�.......... SCU and FCU Electrical Connections.
�.......... GW-1 and GPS Connections Correct and Valid Signal.
Start-up checks Cooling pump
Electric:
�.......... PHC-3 settings. See PHC-3 manual.
�.......... Check Cooling pump connections are correct and pump runs in correct direction.
Hydraulic:
�.......... PHC-3 settings. See PHC-3 manual.
�.......... Check connections and drive direction