14
4.
Lay the jump mat (9) on the ground inside the assembled
frame.
Make sure that the two warning decals are on
top of the Mat and are located in the center, between the
two legs of the trampoline as shown
.
Caution: It is wise to wear leather gloves while attach-
ing the Springs. Be careful where you place your
hands as the Springs and frame joints can pinch.
9
11
11
11
11
V-rings
Align opening of enclosure
as shown here, centered in
between the legs of the
trampoline.
Warning Label locate in the
center between the two legs
of the trampoline as shown
If the enclosure was pre-installed on the Bed (Mat)
at the factory. Inspect the attachments of the enclosure
Netting to the trampoline mat (bed). Make certain each of
the V-rings on the trampoline mat (bed) is threaded
through the corresponding “buttonhole” in the Netting.
Be sure to place the door opening in the enclosure net-
ting so it is centered in between the two legs of the tra-
mpoline where the jumpers will climb off and onto
the trampoline easily as shown.
Put enclosure mesh (7) on the jump mat.
Insert one of the V-rings on the jump mat into one of the
"buttonhole" incisions on the bottom edge of the enclosure
mesh. Continue this process to the other V-rings one by one,
until all the V-rings are inserted though the
“buttonholes”
of the enclosure mesh.
Make certain that each of the V-
rings on the trampoline mat is threaded through the
corresponding 'buttonhole' in the enclosure netting,
and that the door opening of the enclosure is located near
the warning label of Jump mat.
3.
Note: This step requires two persons
. During this
step, you will connect the six assembled leg sections with
the remaining six Top Tubes (1).
Stand two leg sections and hold them in the positions
shown. Slide the large end of one of the remaining Top
Tubes (1) onto the small end of the indicated Top Tube
on one of the leg sections. Insert the small end of the Top
Tube into the indicated Top Tube with T-joint (2) on the
other leg section. Repeat this step until all six leg sections
are connected. When this step is completed, the frame
will be fully assembled and freestanding.
Note: There are 72 V-rings around the edge of the Bed
(Mat) (9) and 72 holes around the top of the frame. In
Steps 4 and 5 you will attach the Bed (Mat) (9) to the
frame, using 72 Springs (11). Make sure your trampoline
mat (Bed) is in the correct position over the leg as shown
in the diagram.
1
Leg Section
Leg Section
Small
End
Large
End
Socket
“T”-joint
