REV. 1-8-19 Page 23
Square Flat Disc Fire Pits
SECTION C THERMOCOUPLE FLAME SENSE (TFS) INST
ALLA
TION
Fig. 28
Removing the cover from metal box.
LEARNING THE REMOTE CONTROL TO THE MODULE
This fire pit comes standard with one remote controlled
transmitter. The handheld remote is shipped with this system
already learned (programmed) to the module inside the
control box. Additional transmitters can be learned to this
electronic module; up to a total of three transmitters are
available. Contact Firegear to discuss additional transmitter
options or see the accessory page of this instruction manual.
Learning the new transmitters will require pressing the learn
button on the module. You should learn any new
transmitters before the final installation of the fire pit.
Follow the steps below:
1.
Remove the two screws securing the cover on the
control box (See Fig. 28). The cover will slide
down exposing the gas valve and control module.
2.
Find the black module attached to the inside of the
control box. Locate the “Learn Button” on the bottom
of the module.
3.
Once the Learn button is located, press and release
the button once. You will hear a beep indicating that
the module is ready to receive a transmitter code
(See Fig. 29)
4.
Take the transmitter and press the OFF button. You
will hear a series of rapid beeps indicating the module
has accepted the new code.
NOTE
: A maximum of three (3) codes can be programmed to
the module. After a total of three (3) codes have been pro-
grammed the memory is full and will not accept any additional
codes. To clear all codes, press and hold the learn button for
10 seconds. The module will beep three (3) times
indicating the memory is clear of all codes. After codes have
been cleared see to Step #3 above to re-learn transmitter.
Learn Butt
on
AUX
POWER
PEN
MODULE
INSIDE FIRE PIT
METAL BOX
Fire Pit Valve Box
Fig. 29
Learn button location
INSTALLATION OF LAVA ROCK/MEDIA INTO BURNER PAN
Install lava rock/media into the burner pan. Ensure the media is a minimum of
1 to 2-inch diameter for proper operation.
Note:
Do not pour lava rock directly
from bag. Media should be placed naturally and NOT packed in tight. Loose fitting
is important to ensure robust flames. Be sure rocks are free of any excessive
dust. This prevents the burner pan weep holes from being plugged and holding
water.
IMPORTANT
: Do not place media over top or under the screen cover.
The screen must be free of any debris to ensure proper lighting of burner and to
allow proper heating of the thermocouple.
Cover the burner completely with media but do not make the depth greater than
1-inch overtop of the burner portholes.
Decorative glass may be loosely scattered on top of the lava rock. Do NOT cover
the stainless steel screen cover with any rock or glass. It must be free an any
media/debris to operate properly.
Lava Rock
Lava Rock
Lava Rock
Ignition Hood
Screen Cover
Fig. 30
Keep screen cover exposed
f i r e - p a r t s . c o m
