REV. 1-8-19 Page 22
Square Flat Disc Fire Pits
Battery
Pack
Junction Box
Weatherproof
Cover/Lid
Battery Pack
Cover Plate
Rubber Gasket
Wires from
Valve Box
Red Wire
Black Wire
4-PIN
Connector
Red Wire
Black Wire
INSTALLATION OF BATTERY INTO TRANSMITTER
You have one handheld transmitter and you will need to install the included (12-volt battery) into the transmitter. Slide the
battery cover off the case, on the backside of the transmitter. Place the battery into the compartment matching positive-to-
positive and negative-to-negative. To ensure the battery is properly installed push any button on the
transmitter and you will see a red LED light at the top of the transmitter glow. The red LED light will only be lit when a
button is pushed. See Fig. 27.
Fig. 26
Weatherproof cover/lid installation.
INSTALLING BATTERY PACK INTO WEATHERPROOF BOX
After the weatherproof box location has been established and installed, run the black 4-PIN connector wire along with the
red and black wires from the valve box into the weatherproof box. Connect red to red and black to black wires from the
valve box to the wires of the battery pack. Connect the 4-PIN connector into the back of the battery pack.
Next secure the battery pack into the weatherproof box as shown in Fig.26
LOW
HI
OFF
ON
12
V
12
V Ba
tter
y
SECTION C THERMOCOUPLE FLAME SENSE (TFS) INST
ALLA
TION
Fig. 27
Installing battery into transmitter.
f i r e - p a r t s . c o m
