SkyPilot SkyExtender DualBand, Инструкция по установке и настройке

Страница: 48 / 79

SkyPilot SkyExtender DualBand Installation and Setup Guide 48
NOTE
The SkyExtender DualBand does not have to be connected to a
SkyPilot mesh network while you’re configuring it for access point
operations via an 802.11b/g wireless connection.
If the SkyExtender DualBand is also connected to the wireless mesh network and
is receiving an IP address from a DHCP server, you’ll have to view the DHCP log to
identify the IP address.
To connect to the access point from the Wi
-
Fi network:
1
Set up your host computer’s 802.11b/g interface to connect to the SSID
SkyPilotDualBand,
the default WLAN configured for the SkyExtender
DualBand access point.
The default WLAN
SkyPilotDualBand
employs a WPA-PSK protection scheme
that uses a public key (password) of
publicpublic
to control access. You’re
prompted for this key when you connect to the SSID from your computer.
2
Set an IP address for your computer’s 802.11b/g interface.
If the SkyExtender DualBand is not connected to a DHCP server via the
SkyPilot mesh network, enter the IP address
192.168.0.9
and apply the
setting.
If the SkyExtender DualBand is connected to a SkyPilot mesh network and
receiving an IP address from a DHCP server, use an IP address that’s within
the address space the DHCP server is using for device assignments.
3
Confirm that your computer can communicate with the SkyExtender
DualBand access point.
Ping the IP address of the access point, either the default
192.168.0.3
or the
address assigned to it by a DHCP server. (This is same IP address you use to
connect to the access point’s Web-based configuration tool.)
If you can successfully ping the access point’s IP address, go to the next
section for instructions on starting the Web-based configuration tool.
If you cannot ping the IP address, you need to troubleshoot the problem
before proceeding. See Appendix A, “Connecting to the Access Point