SkyPilot SkyExtender DualBand, Инструкция по установке и настройке

Страница: 17 / 79

SkyPilot SkyExtender DualBand Installation and Setup Guide 17
Setting up a Radius server for authenticating users
If you plan configure your SkyExtender DualBand access point for WPA, you must
first configure a Radius server with the following:
o
The IP address and shared secret of the SkyExtender DualBand access point.
o
EAP-PEAP/MSCHAPv2 and EAP-TTLS/PAP or MSCHAPv2 (not EAP-TLS) suitable
for WPA. Your Radius supplier can provide instructions.
o
A Users database with user names and passwords. You may also need to
identify a proxy Radius if you’re delegating some domains to other service
providers.
Preparing software images
The next steps for automatic configuration of the SkyExtender DualBand start
with preparing the software images, as described in this section, and continue
with the procedures described in the remaining sections of this chapter. For
information related to manual configuration, turn to Chapter 5, “Using the Access
Point Configuration Tool.”
Before you use the EMS software to set up automatic configuration of the
SkyExtender DualBand, make sure the most current software images are available
to the EMS client software. (You can identify software images by the prefixes and
version numbers in their names—for example,
SkyGate.2.0.14.bin
,
SkyConn.2.0.14.bin
,
SkyExt.2.0.14.bin
, and
SkyExtDB.2.0.14.bin
.)
To provide the EMS software with access to the software images, copy the
images to the directory
/var/ftp/pub/images/
on the provisioning server.
Starting the EMS client
After confirming that the current software images are in the appropriate
directory, you can run the EMS client software and start setting up automatic
configuration of the SkyExtender DualBand.
You‘ll run the EMS client software from a computer on the wireless mesh network
and use SkyProvision™ to set up a node profile for the SkyExtender DualBand.